Uc100 Cnc Motion Controller Driver

After installing the software, the next step is to install a motion controller and licence.

Double left click on the “UC100 CNC motion controller” row in the list and the following screen will popup: Select the Driver TAB page. . The UC100 is in itself a dedicated CNC motion controller. It is far more than a simple USB to parallel converter. Typically when you plug in your LPT cable to the machine it is connected to a breakout board. The UC100 can be plugged directly into the same connection on your machine.

Once the UCCNC licence has been purchased, you will receive a licence file via email that is keyed to the UC100 you also purchased. Copy this file into the directory where you installed the UCCNC software.

Driver

Uc100 Cnc Motion Controller Driver Updater

Select the UC100 CNC motion controller from the list. If selecting the “Dont ask me this again” then this screen will not popup anymore when starting Mach3 and the default driver will be the UC100 in this case. So I finally got to the point of getting my home cnc machine ready for running. Problems right off the get go with the driver install. I'm installing on a windows 7 64bit system. Version of Mach 3 is Version R3.043.066 and installing a UC100 USB motion controller (V2.148) since there is no parallel port. When I start mach these errors pop up.

The UC100 comes with a connector/controller and a cable.

You can purchase the UC100 here:

Plug the cable into the controller as shown here.

Plug the other end into a USB port on your computer. Once the UC100 is connected to the computer, it will search for the driver. In most cases it will locate the driver (included with the UCCNC software install) and you will be prompted that your UC100 is ready to use.

If the driver does not get installed, dont panic. Just open the UC100 entry in the device manager and do a driver update.

Select the browse for driver option and point to the UCCNC installation directory.

Uc100 cnc motion controller driver

That's it. Its time to do some specific machine configurations.

Comments are closed.